Small End Bushing Extractor Tool
Small End Bushing Extractor Tool
4.0 / 5.0
(2) 2 total reviews
Couldn't load pickup availability
Renewing your small end bushing is now made easy with our new USA made bushing extractor tool. Using this tool will allow you to remove and also install your small end bushing all at the same time. Very similar to the Triumph version that was shown in the workshop manual. Tool can be used on many vintage British motorcycles from Triumph, BSA, Norton, Matchless and others including singles, twins and triples.
- Made in the USA
- Instructions included
- Free shipping in the USA
Share
If you want to, you can remove the old bushing and install a new one in a single action. Too easy.
This tool works, I guess, but it really needs some revision. the bolt refuses to stay centered in the bore, and so it slides out of center and then digs into the insides of the new bushings really bad. further, the section of pipe included slips on the face of the rod end, which chews away at it quite a lot. oiling the space between the washer and the pipe helped, but not much. this kit really needs some kind of spacer to keep the threads away from the inner face of the bushings. Maybe some kind of shouldered washer to keep it share in the new bush, or even a second of tube that can fit inside the old bushings... - I considered using my old wrist pin, but the bolt was too thick to fit through it... Point being: if this tool was better, I wouldnt have had to spend 50$ on a 17.5mm adjustable reamer tool to ream out the chowdered insides of the brand new bushings... such is life...